ABB DressPack IRB 6640, Руководство по эксплуатации продукта

Страница: 323 / 370

The procedure below details how to replace the air filter element on the Water and
Air unit.
Note Action
Turn off the hand operated air valve and make sure
that the air filter is not pressurized. 1
Remove the bowl assembly, by following these
steps:
• Push the bowl assembly lock button.
• Lift the bowl assembly.
• Rotate the bowl assembly 45° (right or left).
• Pull out the assembly.
2
Remove the baffle, filter element and deflector by
rotating the baffle counterclockwise by hand. 3
Deflector direction: Concave, fa-
cing the filter element. Fit the deflector to the body assembly. Mind the fit-
ting direction of the deflector (concave in which the
element goes into). 4
Fit the new filter element by inserting it to the de-
flector concave. 5
Baffle direction: Convex, facing
the filter element. Fit the baffle by inserting it to the filter element.
Mind the fitting direction of the baffle (convex to
which the element goes). 6
Tightening torque: 0.9 Nm Tighten the baffle to settle the baffle, filter element
and deflector by rotating the baffle counterclockwise
until it contacts the element and deflector lightly. 7
Rotate approximately one half revolution counter-
clockwise further in order to tighten them.
Note
Check that the lock button has
tossed up!
Fit the bowl assembly.
Match the mating mark of the body and the bowl
assembly to insert the assembly to the body. Rotate
the assembly 45° (right or left) until the lock button
is tossed up to fit the bowl assembly. 8
Product manual - DressPack/SpotPack IRB 6640 323
3HAC028638-001 Revision: K
© Copyright 2007-2018 ABB. All rights reserved.
4 Repair
4.4.4 Replacement of Air filter element
Continued