ZyXEL Communications Prestige 662HW Series, User Manual

Page: 348 / 458

Prestige 662HW Series User’s Guide
37-6 Firmware and Configuration File Maintenance
2.
Enter “open”, followed by a space and the IP address of your Prestige.
3.
Press
[ENTER]
when prompted for a username.
4.
Enter your password as requested (the default is “1234”).
5.
Enter “bin” to set transfer mode to binary.
6.
Find the “rom” file (on your computer) that you want to restore to your Prestige.
7.
Use “put” to transfer files from the Prestige to the computer, for example, “put config.rom rom-0”
transfers the configuration file “config.rom” on your computer to the Prestige. See earlier in this
chapter for more information on filename conventions.
8.
Enter “quit” to exit the ftp prompt. The Prestige will automatically restart after a successful restore
process.
37.3.2 Restore Using FTP Session Example
Figure 37-4 Restore Using FTP Session Example
Refer to section 37.2.5 to read about configurations that disallow TFTP and FTP over WAN.
37.4 Uploading Firmware and Configuration Files
This section shows you how to upload firmware and configuration files. You can upload
configuration files by following the procedure in the previous
Restore Configuration section or by
following the instructions in Menu 24.7.2 – System Maintenance – Upload System Configuration
File .
WARNING!
Do not interrupt the file transfer process as this may
PERMANENTLY DAMAGE YOUR Prestige.
37.4.1 Firmware File Upload
FTP is the preferred method for uploading the firmware and configuration. To use this feature, your
computer must have an FTP client.
When you telnet into the Prestige, you will see the following screens for uploading firmware and the
configuration file using FTP.
ftp> put config.rom rom-0
200 Port command okay
150 Opening data connection for STOR rom-0
226 File received OK
221 Goodbye for writing flash
ftp: 16384 bytes sent in 0.06Seconds 273.07Kbytes/sec.
ftp>quit