ZyXEL Communications Prestige 662HW Series, User Manual

Page: 360 / 458

Prestige 662HW Series User’s Guide
39-2 Remote Management
Figure 39-1 Menu 24.11 Remote Management Control
The following table describes the fields in this menu.
Table 39-1 Menu 24.11 Remote Management Control
FIELD DESCRIPTION EXAMPLE
Telnet Server
FTP Server
Web Server Each of these read-only labels denotes a service or protocol.
Port This field shows the port number for the service or protocol. You
may change the port number if needed, but you must use the same
port number to access the Prestige. 23
Access Select the access interface (if any) by pressing the [SPACE BAR].
Choices are:
LAN only , WAN only , All or Disable . The default is
LAN only .
LAN only
Secured Client IP The default 0.0.0.0 allows any client to use this service or protocol
to access the Prestige. Enter an IP address to restrict access to a
client with a matching IP address. 0.0.0.0
Once you have filled in this menu, press [ENTER] at the message "Press ENTER to Confirm or ESC to
Cancel" to save your configuration, or press [ESC] to cancel.
39.2.2 Remote Management Limitations
Remote management over LAN or WAN will not work when:
♦ A filter in menu 3.1 (LAN) or in menu 11.5 (WAN) is applied to block a Telnet, FTP or Web
service.
♦ You have disabled that service in menu 24.11.
♦ The IP address in the Secured Client IP field (menu 24.11) does not match the client IP
address. If it does not match, the Prestige will disconnect the session immediately.
♦ There is already another remote management session with an equal or higher priority running.
You may only have one remote management session running at one time.
Menu 24.11 - Remote Management Control
TELNET Server:
Server Port = 23 Server Access = LAN only
Secured Client IP = 0.0.0.0
FTP Server:
Server Port = 21 Server Access = LAN only
Secured Client IP = 0.0.0.0
Web Server:
Server Port = 80 Server Access = LAN only
Secured Client IP = 0.0.0.0
Press ENTER to Confirm or ESC to Cancel: