ZyXEL Communications Prestige 662HW Series, User Manual

Page: 345 / 458

Prestige 662HW Series User’s Guide
Firmware and Configuration File Maintenance 37-3
4.
Enter your password as requested (the default is “1234”).
5.
Enter “bin” to set transfer mode to binary.
6.
Use “get” to transfer files from the Prestige to the computer, for example, “get rom-0 config.rom”
transfers the configuration file on the Prestige to your computer and renames it “config.rom”. See
earlier in this chapter for more information on filename conventions.
7.
Enter “quit” to exit the ftp prompt.
37.2.3 Example of FTP Commands from the Command Line
Figure 37-2 FTP Session Example
37.2.4 GUI-based FTP Clients
The following table describes some of the commands that you may see in GUI-based FTP clients.
Table 37-2 General Commands for GUI-based FTP Clients
COMMAND DESCRIPTION
Host Address Enter the address of the host server.
Login Type Anonymous.
This is when a user I.D. and password is automatically supplied to the
server for anonymous access. Anonymous logins will work only if your
ISP or service administrator has enabled this option.
Normal.
The server requires a unique User ID and Password to login.
Transfer Type Transfer files in either ASCII (plain text format) or in binary mode.
Initial Remote Directory Specify the default remote directory (path).
Initial Local Directory Specify the default local directory (path).
37.2.5 TFTP and FTP over WAN Management Limitations
TFTP, FTP and Telnet over WAN will not work when:
♦
You have disabled Telnet service in menu 24.11.
♦
You have applied a filter in menu 3.1 (LAN) or in menu 11.5 (WAN) to block Telnet service.
331 Enter PASS command
Password:
230 Logged in
ftp> bin
200 Type I OK
ftp> get rom-0 zyxel.rom
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 16384 bytes sent in 1.10Seconds 297.89Kbytes/sec.
ftp> quit