ZyXEL Communications Prestige 128IMH, User Manual, Page: 84 / 142

ZyXEL Prestige 128IMH User’s Guide
Page 10-2
¿ ù » ~
!
© |¥ ¼ © w ¸ q¼ Ë ¦ ¡ ¡ C
to the Ethernet Address Timeout parameter in each remote node. When a remote
Ethernet address is aged out, there is no need to maintain its connection to the IPX
server.
From Menu 3 - Ethernet Setup, enter
4
to go to Menu 3.4 - Bridge Ethernet Setup
shown below. Set Handle IPX to None if there is no IPX traffic on the LAN or if you do
not want to apply any special handling for IPX. Set it to Client if there are only client
workstations on the LAN. Set to Server if there are any IPX servers on the LAN.
If there are both clients and servers on the LAN, then the setting depends on if the local
clients will access the remote servers. If they do, set to
Client and set Dial-On-Broadcast
in menu 11.2 to Yes to allow the client queries to trigger the call. If they do not, set it to
Server.
Figure 10-1 Bridge Ethernet Setup
When you are finished, press
ENTER
at the message: ‘Press ENTER to Confirm ...’ to
save your selections or press
ESC
at any time to cancel them.
10.3. LAN-to-LAN Application
A typical LAN-to-LAN application is to use the Prestige to call from one office to another
office such that services on one network have access to services on the remote side and vice
versa. You need to configure a remote node in order to dial out to another office.
10.3.1. Remote Node Setup
Follow the procedure in Chapter 6 to fill the protocol-independent parameters in
menu 11,
Remote Node Profile
. For the bridging specific parameters, follow the ensuing
instructions:
1. Bridge - Make sure this field is set to
Yes
.
Menu 3.4 - Bridge Ethernet Setup
Handle IPX= None
Press ENTER to Confirm or ESC to Cancel:
Press Space Bar to Toggle.