ZyXEL Communications Prestige 128IMH, User Manual, Page: 55 / 142

Prestige 128IMH User’s Guide ZyXEL
¿ ù » ~
!
© |¥ ¼ © w ¸ q¼ Ë ¦ ¡ ¡ C
Page 6-7
Field Description
Encapsulation Select the vendor specific encapsulation for this remote node
either Standard PPP where Standard PPP choices are used or
Cisco PPP where Cisco PPP choices are used.
Compression
Turn on the Stac

Compression. The default for this field is Off.
Multiple Link Options:
BOD Calculation Select the direction of the traffic you wish to calculate in order to
determine when to add or subtract a link. The default for this
field is Transmit or Receive.
Multiple Link Options:
Base Trans Rate Select the base data transfer rate for this remote node in Kbps.
There are two choices for this field:
64 - Only one channel is used.
128 - Two channels are used as soon as a packet triggers a call
Multiple Link Options:
Max Trans Rate Enter the maximum data transfer rate allowed for this remote
node. This parameter is in kilobits per second. There are two
choices for this field- as above.
Multiple Link Options:
Target Utility Enter the two thresholds separated by a ‘ -’ for subtracting and
adding the second channel. The default is 32-48.
Multiple Link Options:
Add Persist This parameter specifies the number of seconds when traffic is
above the adding threshold before the Prestige brings up the
second channel. The default is 5 seconds.
Multiple Link Options:
Subtract Persist - This parameter specifies the number of seconds when traffic is
below the subtraction threshold before the Prestige drops the
second channel. The default is 5 seconds.
Table 6-1 Remote Node PPP Options Fields
Once you have completed Menu 11.2 - Remote Node PPP Options, press ENTER at the
message: ‘Press ENTER to Confirm ...’ to save your configuration or press ESC at any
time to cancel.
6.3. Configuring Backup ISP Accounts
Sometimes it may be desirable to configure more than one ISP account for backup purposes.
This can be accomplished by configuring an unused remote node with your ISP’s
information. Single User Account can be also be enabled, making it convenient to switch
Internet Service Providers in case of a failure.
To configure a backup ISP,
1. Configure your primary ISP using menu 4, as described earlier in this chapter.
2. Enter menu 11, then select the number of an unused remote node.

Registered Trademark