ZyXEL Communications Prestige 128IMH, User Manual, Page: 70 / 142

ZyXEL Prestige 128IMH User’s Guide
Page 8-4
¿ ù » ~
!
© |¥ ¼ © w ¸ q¼ Ë ¦ ¡ ¡ C
Figure 8-2 Menu 11.3 - Remote Node Network Layer Options
Field Description
Rem IP Address This shows the IP address you entered for this remote node
in the previous menu.
Rem IP Subnet Mask
Enter the subnet mask for the remote network.
My WAN Addr
Enter the IP address assigned to the WAN port of the
Prestige.
Single User Account Set this field to Yes to enable the Single User Account
feature when calling this remote node.
Metric
IP routing uses hop count as the measurement of cost, with a
minimum of 1 for directly connected networks. The number
need not be precise, but it must be between 1 and 16.
Private
This parameter determines if the Prestige includes the route
to this remote node in its RIP broadcasts. If set to Yes, this
route is kept private and not included in RIP broadcast. If No,
the route to this remote node will be propagated to other
hosts through RIP broadcasts.
RIP Both, In Only, Out Only, or None.
Version
Unless there are routers in your environment that do not
understand RIP-2 packets, you should probably set this field
to RIP-2B. Choices are RIP-2B, RIP-2M or RIP-1 .
Table 8-1 Menu 11.3 - Remote Node Network Layer Options
Menu 11.3 - Remote Node Network Layer Options
IP Options: IPX Options:
Rem IP Addr: 0.0.0.0 Dial-On-Query= N/A
Rem Subnet Mask= 0.0.0.0 Rem LAN Net #= N/A
My WAN Addr= 0.0.0.0 My WAN Net #= N/A
Single User Account= Yes Hop Count= N/A
Tick Count= N/A
Metric= 2 W/D Spoofing(min)= N/A
Private= No SAP/RIP Timeout(min)= N/A
RIP Direction= Both
Version= RIP-2B Bridge Options:
Dial-On-Broadcast= N/A
Ethernet Addr Timeout(min)= N/A
Enter here to CONFIRM or ESC to CANCEL: