ZyXEL Communications Prestige 128IMH, User Manual, Page: 68 / 142

ZyXEL Prestige 128IMH User’s Guide
Page 8-2
¿ ù » ~
!
© |¥ ¼ © w ¸ q¼ Ë ¦ ¡ ¡ C
8.2. LAN-to-LAN Application
A typical LAN-to-LAN application is to use the Prestige to call from a branch office to the
headquarters as depicted in the following diagram:
Figure 8-1 LAN-to-LAN Application
For the branch office, you need to configure a remote node in order to dial out to the
headquarters. Additionally, you may also need to configure Static Routes if some services
reside beyond the immediate remote LAN.
8.2.1. Remote Node Setup
Follow the procedures in Chapter 0 to fill the protocol-independent parameters in Menu
11.1, Remote Node Profile. For the TCP/IP specific parameters, follow the instructions
below. If you are configuring the Prestige to receive incoming calls, you also need to set the
default dial-in parameters in menu 13 (see Chapter 1).
♦
Route - Make sure IP is among the protocols in the Route field.
♦
IP Address - Enter the IP address of the gateway at the remote site (in this case,
headquarters).
♦
Edit IP/IPX/Bridge - Press the space bar to change it to
Yes
and press
ENTER
to go
to the Menu 11.3 - Remote Node Network Layer Options menu shown below.