ZyXEL Communications MAX-207HW2, User Manual

Page: 104 / 180

Chapter 9 The System Configuration Screens
User’s Guide
105
9.4.1 The Restore Configuration Process
When the WiMAX Modem restores a configuration file, the device automatically
restarts. This causes a temporary network disconnect.
Note: Do not turn off the device while configuration file upload is in progress.
If the WiMAX Modem’s IP address is different in the configuration file you selected,
you may need to change the IP address of your computer to be in the same
subnet as that of the default management IP address (192.168.5.1). See the
Quick Start Guide or the appendices for details on how to set up your computer’s
IP address.
You might have to open a new browser to log in again.
If the upload was not successful, you are notified by Configuration Upload Error
message:
Click Return to go back to the Configuration screen.
9.5 Restart
Click ADVANCED (
進階
) > System Configuration (
系統組態
) > Restart to
reboot the WiMAX Modem without turning the power off.
Note: Restarting the WiMAX Modem does not affect its configuration.
Figure 43 ADVANCED (
進階
) > System Configuration (
系統組態
) > Restart
The following table describes the labels in this screen.
Table 37 ADVANCED (
進階
) > System Configuration (
系統組態
) > Firmware
LABEL DESCRIPTION
Restart Click this button to have the device perform a software restart. The
Power LED blinks as it restarts and the shines steadily if the restart is
successful.
Note: Wait one minute before logging back into the WiMAX Modem
after a restart.