ZIEHL-ABEGG CXE/AV, Operating Instructions Manual, Page: 45 / 121

Setting T-Start SA
Setpoint reducing will start below this outside temperature
Setting range: -10.0...40.0
° C
Factory setting: 15.0
°
C
15 ° C
T-Start SA
Setting Min. Setpoint
Minimum pressure for very low outside temperature
Setting range: in measuring range of sensor
Factory setting: 70 Pa
70.0 Pa
Min. Setpoint
9.5 Volume control 5.01 and 5.02
9.5.1 Basic setting 5.01 and 5.02
Main menu Base setup
Start up
Setting
Protocol
Base setup
Controller Setup
Base setup Mode
Mode selection e.g. 5.01
5.01
Mode
Base setup E1 Analog In
The sensor input is factory set for modes of group 5 to sensor type “ DSG200 ” .
Measuring range: 0...200 Pa
Output signal: 0 - 10 V
Connection terminals:
“ E1 ” , “ GND ” , “ 24V ”
Other settable sensors / measuring ranges:
• “ DSG 50 ”
,
“ DSG100 ”
,
“ DSG200 ”
,
“ DSG300 ”
,
“ DSG500 ”
,
“ DSG1000 ”
,
“ DSG2000 ”
,
“ DSG4000 ”
,
“ DSG6000 ”
, INT300, INT500 (numerical data meas-
uring range [Pa], output signal 0 - 10 V). Type designation DSG... pressure
sensor with new type designation MPG..
•
0 - 10 V, 0 - 20 mA, 4 - 20 mA (for sensors with free measuring range and linear
characteristic)
The sensor measuring range must be entered for sensors with free measuring range in
order to display the actual value correctly.
Example with a 0 - 10 V sensor and 0 - 400 Pa measurement range:
E1 Analog In = 0 - 10 V, E1 Min. = 0,0 Pa, E1 Max. = 400 Pa
DSG200
E1 Analog In
Base setup K Factor
Input of the “ K factor ” dependent on the fan (inlet duct).
setting range: 0...5000
Factory setting: 75
The K-factors (Nozzle coef
fi cients) of ZIEHL-ABEGG fans can be found in the following
table. Please contact the manufacturer for K-factors of unlisted fans.
75
E1 K-Factor
Base setup E1 Offset
Sensor calibration with calibrated comparison device.
0.0 Pa
E1 Offset
Operating Instructions UNIcon MODBUS Master Programming
L-BAL-E255-GB 1901 Index 001 Part.-No.
45/121