1
Spare auxiliary supply fuse
500mA 20mm
1
Spare mains fuse
3.15A 20mm
1
Spare battery fuse
6.3A
2
Spare alarm circuit end of line
resistors.
3k9 0.25W
5
Spare remote input circuit end of
line resistors.
3k9 0.25W
2
Engineers door keys
Key Ref.: 801
2
Access control keys
Key Ref.: 850 or 901
1
Positive battery lead
Red
1
Negative battery lead
Black
1
Battery connection lead
Blue
8.2.1Premier AL Panel Installation Instructions
1. Remove the main ribbon cable from the display board header.
2. Remove the ribbon cable clamp on the door to release the cables. Fold the cable
into the back box. Replace the ribbon clamp onto the door.
3. Remove the earth strap connecting the door and back box by removing the nut and
washer on the door. Carefully note the arrangement and replace the nut and
washer.
4. Unscrew the hinge pin at the bottom of the door whilst supporting the door. Swing
the bottom of the door clear of the back box and release the top of the door from
its hinge pin.
5. Carefully put the door on one side and replace the hinge pin in the back box.
6. Remove the earth strap connecting the back box and chassis by removing the nut
and washer on the chassis. Carefully note the arrangement and replace the nut and
washer.
7. Unscrew the two lower chassis screws and slacken the top two mounting screws
.
8. Carefully lift the chassis upward to align the screw heads with the large holes in
the chassis keyholes and lift the chassis clear of the back box.
9. Place the chassis carefully to one side.
10. Place the chassis and door into the carton. Store the carton in a safe place until
installation is complete.
11. Identify the three indented holes that are used to mount the enclosure.
12. Place the enclosure in the desired location and mark the position of the top
indented hole. Remove the enclosure and fit a suitable fixing to the wall. Hang the
enclosure from the top fixing point and ensure that it is level. Mark the locations
of the other two mounting holes.
13. Remove the enclosure from the wall and fit suitable fixings to the two remaining
mounting points. Fit the enclosure to the wall using all three mounting points.
Page 15 of 111
02/10/03
