26
Reference Manual
Input channels
O
ST
Input channels
This chapter explains various operations for input channels.
STEREO channels
These channels are used to process stereo signals. When the CL series console is in the
default state, the input signal from the EFFECT RACK 1 - 8 is assigned.
MIX
M
O
ST
N
MATRIX CUE
Signal flow for input channels
The input channels comprise the section that processes signals received from the I/O
devices, rear panel input jacks, or slots 1-3, and sends them to the STEREO bus, MONO bus,
MIX buses, or MATRIX buses. There are two types of input channels, as follows.
MONO channels
These channels are used to process monaural signals. When the CL series console is in the
default state, the input signal from the Dante connector is assigned.
1 2 2324 L R(C) 1 2 7 8 L R
MIX
M
O
N
O
MATRIX CUE
•
INPUT PATCH
1 2
...
2324 L R(C) 1 2
...
7 8 L R
Assigns input signals to the input channels.
•
Ø (phase)
Switches the phase of the input signal.
•
DIGITAL GAIN
Attenuates/boosts the level of the input signal.
•
HPF (High Pass Filter)
Cuts the region below the specified frequency.
•
4 BAND EQ (4 band equalizer)
A parametric EQ with four bands: HIGH, HIGH MID, LOW MID, and LOW.
•
DYNAMICS 1
This is a dynamics processor that can be used for gating and ducking, or as an expander
or compressor.
•
DYNAMICS 2
This is a dynamics processor that can be used as a compressor, compander, or de-esser.
•
INPUT DELAY
Corrects input signal delay. You can specify up to 1000ms.
•
LEVEL/DCA 1-16
Adjusts the input level of the effect.
•
ON (On/off)
Turns the input channel on or off. If this is off, the corresponding channel will be muted.
INP
UT
PA
T
CH
INP
U
T
PA
T
CH
USO
RESTRITO
Summary of Contents for CL5
Page 257: ...Data List USO RESTRITO ...
