Xerox WorkCentre 5230A, System Administration Manual

Page: 279 / 454

E-mail Installation
279
10.
Using the same method as in step 6, enter a gateway address.
NOTE: If you do not wish to set the gateway address, leave this field blank.
11.
Select [IPv4 – IP Filter], and then [Change Settings].
12.
Select [Enabled] to filter access to the machine.
NOTE: If you do not wish to use the IP filter feature, select [Disabled].
NOTE: Use CentreWare Internet Services to register the IP addresses which are not
allowed to access the machine. Refer to
CentreWare Internet Services on page 149
.
13.
When you have finished establishing TCP/IP, select [Close] on the [Protocol
Settings] screen.
When [IPv6 Mode] or [Dual Stack] is selected in step 2
3.
Set [IPv6 Address Manual Configuration].
NOTE: Select [Enabled] when the machine is connected to a network on which IPv6
stateless address autoconfiguration is disabled, or when you want to set a static IPv6
address.
If you selected [Enabled] in step 3, proceed to step 4. Otherwise, proceed to step 10.
4.
Select [Manually Configured IPv6 Address], and then [Change Settings].
5.
Use the keypad on the screen to enter an IP address for the machine in the format
“xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx”. Select [Save].
6.
Select [Manually Configured IPv6 Prefix], and then [Change Settings].
7.
Enter an IP address prefix, and then select [Save].
8.
Select [Manually Configured IPv6 Gateway], and then [Change Settings].
9.
Using the same method as in step 5, set a gateway address.
10.
Select [IPv6 – IP Filter], and then select [Enabled] or [Disabled].
NOTE: If you do not wish to use the IP filter feature, select [Disabled].
NOTE: Use CentreWare Internet Services to register the IP addresses which are not
allowed to access the machine. Refer to
CentreWare Internet Services on page 149
.
11.
When you have finished establishing TCP/IP, select [Close] on the [Protocol
Settings] screen.
E-mail Setting Setup
Finally, set the other items required for the e-mail feature.
1.
Select [System Settings] in the menu at the left side of the screen.
2.
Select [Connectivity & Network Setup] in the [Group] menu.