Xerox WorkCentre 5230A, System Administration Manual

Page: 249 / 454

UNIX TCP/IP
249
-a Deletes all the print data belonging to the user issuing the command,
from the specified printer.
-e Deletes all the print data from the specified printer.
-u user name Deletes all the print data belonging to the specified user, from the
specified printer.
• job number
This option specifies the job number of the print data to be deleted. These numbers can
be checked by issuing an lpstat command.
This option is only valid in the spool mode.
NOTE: Print data which consists of multiple files sent in one print instruction cannot be
deleted file by file. All the files will be deleted together.
NOTE: This command is invalid if no options are specified, or if there is no print data
which matches the option.
NOTE: You can only delete print data from the same workstation used to send the
print data. You cannot delete print data sent by other workstations.
NOTE: When a command to delete print data is received, the file will be deleted even
if it is in the process of being printed. Any unprinted data will be cancelled after the file
has been deleted.
Example
To delete the print data from printer fxPS for job number 27, enter the following
command.
%cancel fxPS-27
To delete all the print data from printer fxPS, enter the following command.
%cancel fxPS -e
SunOS
This section describes printing from a workstation running SunOS. See the manuals
supplied with the workstation for full details.
Print (lpr)
The lpr command is used to print.
Command format
/usr/ucb/lpr [-P printer name] [-# number of copies]
[-C parameter] File name
Command options
The following command options are available.
• -P printer name
This option specifies the printer name registered at /etc/printcap. If this option is
omitted, print data will be output to the default printer lp.
• -# number of copies
This option specifies the number of copies. If one lpr command is issued to print
multiple files, the number of copies specified by this option will apply to all the files.
This option is only valid in the spool mode.