Xerox WorkCentre 5230A, System Administration Manual

Page: 238 / 454

8 Printer Environment Settings
238
NetWare Setup
For more information, refer to
NetWare Setup on page 239
.
Computer Setup
For more information, refer to
Computer Setup on page 239
.
Test Print
For more information, refer to
Test Print on page 239
.
Network Communication Setup
Use this procedure to set up the network communication parameters of the machine.
At the machine, perform these steps.
NOTE: Keep the SNMP port enabled while you use the machine on the TCP/IP
network.
NOTE: Some of the configuration options for this protocol are only available from
CentreWare Internet Services. Refer to
CentreWare Internet Services on page 149
.
First, enable the NetWare port.
1.
Connect the machine to the network.
2.
Press the <Log In/Out> button on the control panel, and then type the System
Administrator login ID to enter the System Administration mode.
NOTE: The passcode may also be required depending on the machine configuration.
3.
Press the <Machine Status> button on the control panel, and then select the
[Tools] tab on the screen.
4.
Select [System Settings] in the menu at the left side of the screen.
5.
Select [Connectivity & Network Setup] in the [Group] menu.
6.
Select [Port Settings] in the [Features] menu.
7.
Select [NetWare], and then [Change Settings].
8.
Select [Port Status], and then [Change Settings].
9.
Select [Enabled], and then [Save].
Next, establish TCP/IP if you use an IP Address for the NetWare network.
1.
Select [Connectivity & Network Setup] in the [Group] menu, and then select
[Protocol Settings] in the [Features] menu.
2.
Under [TCP/IP - IP Mode], select [IPv4 Mode] or [Dual Stack].
NOTE: [IPv6 Mode] is not available for NetWare settings.
3.
Select [IPv4 - IP Address Resolution], and then [Change Settings].
4.
Select a method for establishing an IP address from [DHCP], [BOOTP], [RARP],
[DHCP/Autonet], and [STATIC], and then select [Save].
NOTE: Use the DHCP server together with the Windows Internet Name Server
(WINS) server.
If you selected [STATIC] in step 4, then proceed to step 5 to configure the protocol
settings. Otherwise, proceed to step 11.
5.
Select [IPv4 - IP Address], and then [Change Settings].