Xerox WorkCentre 5230A, System Administration Manual

Page: 246 / 454

8 Printer Environment Settings
246
on a disk partition large enough to hold copies of documents that will be
submitted.
cd /var / spool / lpd
mkdir PrinterName
chmod 744 PrinterName
HP-UX
Follow the steps below to set up an HP-UX workstation to communicate with the
machine.
1.
Log in as root at a client and add the machine to the /etc/hosts file. For example:
Ip address [tab] PrinterName
2.
Verify connectivity to the machine, by using a UNIX command such as ping from a
terminal command window, as shown in the following example:
ping PrinterName
NOTE: Select CTRL+C to cancel the ping command.
3.
There are two methods to install the machine on an HP-UX workstation. Refer to
one of the following sections to complete the installation:
Using the Command Window TTY Method – page 246
Using the System Administrator Manager (SAM) GUI Method – page 247
Using the Command Window TTY Method
Follow the steps below to use the command window to manually enter command
strings.
1.
Open a command window on the desktop. From the command prompt (#), enter
the information below. Remember that UNIX commands are case-sensitive.
1) Type
su
to access the superuser mode.
2) Type
sh
to run the Bourne shell.
3) Type
lpshut
to stop the print service.
4) Type the following command on one line:
lpadmin -pqueuename -v/dev/null -mrmodel -ocmrcmodel-
osmrsmodel -ob3 -orc -ormhostname -orplp
NOTE: The queuename is the name of the print queue being created. The hostname
is the
PrinterName
for the machine from the etc/hosts file.
The remote queue name must be set to
lp
to spool jobs to the machine. This is set by
the
-orplp
command.
2.
Type
lpsched
to start the print service.
3.
Type
enable queuename
to enable the queue to print to the machine.
4.
Type
accept queuename
to enable the queue to start accepting jobs from the
HP-UX workstation.
NOTE: The queuename is the name of the print queue that has been created.
5.
Type
exit
to exit the Bourne shell.
6.
Type
exit
to exit superuser mode.
7.
Type
exit
to close the command window.