Xerox WorkCentre 5230A, System Administration Manual

Page: 247 / 454

UNIX TCP/IP
247
8.
Continue with Test Print on page 247 .
Using the System Administrator Manager (SAM) GUI Method
Follow the steps below to use the HP System Administrator Manager (SAM) GUI
(Graphical User Interface).
NOTE: Refer to the HP-UX documentation for additional information on using the
System Administrator Manager (SAM).
1.
Start the SAM application.
2.
Select the [Printers and Plotters] icon.
3.
Select [Actions] from the Menu Bar.
4.
Select [Add Remote Printer/Plotter] from the pull-down menu.
5.
Enter the following information into the form displayed in the [Add Remote Printer/
Plotter] dialog box:
1) Printer Name
2) Remote System Name
3) For the Remote Printer Name, enter “lp”.
NOTE: The Printer Name is the name of the print queue being created. The Remote
System Name is the PrinterName for the machine from the etc/hosts file.
The Remote Printer Name must be set to lp to spool jobs to the machine.
4) Enable [Remote Printer on a BSD system] by selecting the check box.
5) Make sure that the [Remote Cancel Model] is set correctly,
6) Make sure that the [Remote Status Model] is set correctly.
7) Make sure that the [Default Request Priority] is set correctly.
8) Make sure that the [Allow Anyone to Cancel a Request] check box is set
correctly.
9) Make sure that the [Make This Printer the Default Destination] check box is set
correctly.
6.
Select [OK].
7.
Read and respond to any system messages displayed.
8.
Continue with
Test Print on page 247
.
Test Print
To make sure that the machine has been installed on the UNIX TCP/IP network
correctly, a test print should be submitted from each client workstation. Perform the
following steps.
1.
Start the Open Windows application.
2.
Send a test print to the machine.
3.
Repeat the procedure for all workstations that will be sending jobs to the machine.
The UNIX TCP/IP installation is now complete.
If the test print fails, refer to
Problem Solving chapter on page 349.