October 2012
1-13
ColorQube 8570/8870 Service Manual
Cleaning Procedures, Final Actions
Service Call Procedures
Xerox Internal Use Only - Revised, 3rd Revision
Clean the Drum Maintenance Wiper Blade Assembly
1.
Remove the Front Door (
REP 1.1
).
2.
Remove the Control Panel Cover (
REP 1.5
).
3.
Remove the Right Side Cover (
REP 1.11
).
4.
Remove the Lower Inner Duplex Guide (
REP 3.2
).
5.
Remove the Inner Simplex Guide with Deskew Sensor and Harness (
REP 3.1
).
6.
Remove the Preheater and Deskew Assembly (
REP 2.20
).
7.
Remove the Drum Maintenance Unit (
REP 1.16
).
8.
Remove the Drum Cooling Fan (
REP 4.12
).
9.
Remove the Drum Maintenance Pivot Plate/Drum Wiper Blade Assembly (
REP 2.17
).
10. Use a lint-free cloth to clean the top and sides of the flexible plastic Wiper Blade.
Figure 12 Cleaning the Wiper Blade
Final Actions
Purpose
The intent of this procedure is to be used as a guide to follow at the end of every service call.
Procedure
1.
Check that the exterior of the printer and the adjacent area is clean. Use a dry cloth or a
cloth moistened with water to clean the exterior of the printer. Do not use solvents.
2.
Check the supply of consumables. Ensure that an adequate supply of consumables is
available according to local operating procedures.
3.
Conduct any operator training that is needed. Ensure the operator understands the peri-
odic maintenance procedures in the User Guide.
4.
Reconnect the printer to the customer network. Verify function by printing one or more
test prints. Present the test prints to the customer as examples of printer performance.
5.
Discuss the service call with the customer to ensure that the customer understands what
has been done and is satisfied with the results of the service call.
Summary of Contents for COLORQUBE 8570
Page 1: ...ColorQube 8570 8870 Printer ColorQube 8570 8870 Service Manual Xerox Internal Use Only...
Page 2: ......
Page 423: ......
