October 2012
6-30
ColorQube 8570/8870 Service Manual
Electrical Troubleshooting
Revised, 3rd Revision - Xerox Internal Use Only
General Troubleshooting
Ink Loader Board LEDs
The Ink Loader Board has two LEDs:
•
+3.3V (green)
•
+50V (red)
These LEDs indicate the same status as the +3.3V and +50V on the Electronics Module.
The +50V will not be on at all time. The +50V can be Off when the printer is at Ready mode.
Figure 7 Ink Loader Board LEDs
Checking Fuses
Fuses can be damaged for various reasons. The following Fuses are included in the Col-
orQube 8570/ 8870 printer. See
Figure 8
for location of the Fuses on the Power Control Board.
Table 2 ColorQube 8570/ 8870 Fuses
Fuses
Description
F301
+3.3V, logic
F302
+50V pwm’ed, to High Capacity Feeder
F303
+50V pwm’ed, to Preheat Solenoid, Head Maintenance Clutch, Head Tilt
Solenoid, Strip Solenoid
F304
+50V pwm’ed, to Deskew Clutch, Pick Clutch, Pick Solenoid
F401
+50V
F402
+50V pwm’ed, to Ink Loader Solenoids
F501
+3.3V Sleep
Summary of Contents for COLORQUBE 8570
Page 1: ...ColorQube 8570 8870 Printer ColorQube 8570 8870 Service Manual Xerox Internal Use Only...
Page 2: ......
Page 423: ......