Power Supply Operation
TM-XDOP-01XN
3–21
Store User Settings
If you have a frequent or constant need for a specific voltage and current output,
you can save these setpoints in the power supply’s memory as a user setting. Once
a setting is stored, it remains in the power supply’s memory after the unit is
powered off.
Ten user setting memory locations are available, and each saves the following
parameters:
•
Voltage setpoint
•
Current setpoint
•
Power setpoint
•
Over-voltage protection setpoint (OVP)
•
Under-voltage protection setpoint and shutdown configuration (UVP)
•
Over-current protection setpoint and shutdown configuration (OCP)
•
Under-current protection setpoint and shutdown configuration (UCP)
•
Over-power protection setpoint and shutdown configuration (OPP)
•
Under-power protection setpoint and shutdown configuration (UPP)
•
Foldback protection mode and delay settings
•
Over-temperature protection auto recovery configuration (OTP)
•
AC Off auto recovery configuration (ACO)
•
Aux line configuration
•
Front panel display configuration
•
Front panel knob lockout
•
Voltage, current, and power limits
•
Triggered voltage, current and power setpoints
•
Trigger source
Important:
All parameters are saved and used when the user setting is
recalled. Therefore, you should set parameters that you do not care about to the
factory defaults.
TM-XDOP-01XN.book Page 21 Monday, July 17, 2006 11:19 AM
Summary of Contents for XDC 10-1200
