![background image](http://html1.mh-extra.com/html/xantrex/xdc-10-1200/xdc-10-1200_operating-manual_3287252263.webp)
Device-Specific Error List
TM-XDOP-01XN
D–5
Device-Specific Error List
An error in the range [-399, 300] or [1, 32767] indicates that the instrument has
detected an error which is not a command, query or, execution error; some device
operations did not properly complete, possibly due to an abnormal hardware or
firmware condition. These codes are also used for self-test response errors. The
occurrence of any error in the class causes the device-specific error bit (bit 3) in
the Event Status Register to be set.
Table D-3
Device-Specific Error List
Error code Error Message Description
-300
Device-specific error.
Indicates that the power supply could not complete the operation due to some
condition of the power supply.
-310
System error.
This error is queued when the power supply cannot convert the input to a
calibrated value.
-313
Calibration memory lost.
-314
Save/recall memory lost.
Indicates that the non-volatile data saved by the *SAV command has been
lost.
-315
Configuration memory lost.
Indicates that non-volatile configuration data saved by the power supply has
been lost.
-321
Out of memory.
An internal operation needed more memory than was available.
-330
Self-test failed.
-350
Queue overflow.
A specific code entered into the queue in lieu of the code that caused the
error. This code indicates that there is no room in the queue and an error
occurred but was not recorded.
-360
Communication error.
This is the generic communication error for errors which cannot be classified
below.
-361
Parity error in program message.
Parity bit not correct when data received.
-362
Framing error in program message.
A stop bit was not detected when data was received, e.g. a baud rate
mismatch.
-363
Input buffer overrun.
Software or hardware input buffer on serial port overflows with data caused
by improper (or nonexistent) pacing.
TM-XDOP-01XN.book Page 5 Monday, July 17, 2006 11:19 AM
Summary of Contents for XDC 10-1200
