![background image](http://html1.mh-extra.com/html/xantrex/xdc-10-1200/xdc-10-1200_operating-manual_3287252192.webp)
Current Sharing
5–6
TM-XDOP-01XN
Errors
The master annuciator will flash if it does not detect any slave units on the
network.
The slave annunciator will flash if it does not detect a master on the network.
Check the cable and the master configuration.
A master or slave will be disabled from current sharing (set to "No share") if:
•
there is more than one master connected to the CANbus, (Error +1911)
•
there are more than 4 slaves, (Error +1922), or
•
the model does not match that of the master, (Error +1922).
In each of these cases, the current share mode will be set to "No share".
If a unit becomes disconnected due to a failure in communications, the master will
queue error
+1912, "Current Share Slave Lost"
and the slave will
queue error
+1921, "Current Share Master Lost."
The slave's
output will be disabled, and the slave annunciator will flash.
See Table D-13, “Current Share Error Codes” on page D–9 for the list of error
codes and messages.
CANbus Specifications
Max cable length
40m
Bus speed
700 kbits/sec
Termination
120 ohm, 1/4 Watt
Connections
parallel male DB9 to female DB9 cable
TM-XDOP-01XN.book Page 6 Monday, July 17, 2006 11:19 AM
Summary of Contents for XDC 10-1200
