TReX User Manual v15.30 Firmware
HIGH
The input is considered to be HIGH on start. If on start the input is read and found to be LOW,
then there will be an immediate transmission (if configured to transmit).
LOW
The input is considered to be LOW on start. If on start the input is read and found to be HIGH,
then there will be an immediate transmission (if configured to transmit).
TX COUNT LOW
If set to 0, then there will there will be NO transmissions when moving to the LOW state. If
non-zero then this is the number of times the LOW message will be transmitted.
If there is a change of state again, then any remaining transmissions are cancelled.
When set to a non-zero TX COUNT, the input level is considered to be ENABLED, and
displayed as ENABLED on the upper menu level.
ALLOW REM LOW
If ENABLED then should multiple retransmissions be configured, if the input state changes to
HIGH (that would normally cancel the remaining transmissions), the remaining LOW
transmissions are allowed to complete in full.
RESEND LOW
If not set to DISABLED, the interval specified is the time in seconds between repeating
retransmissions. This will resend the configured LOW input level message indefinitely at this
interval (Only if the input level is LOW).
RETX DELAY LOW
How long in seconds before sending the next message if set to more than 1.
DEBOUNCE LOW
How long in seconds that the input must be settled at a LOW level before transmitting
THRESH LOW
When configuring inputs 1-8, this field has no function.
On the BATT input this is the voltage that the TReX BATT input is considered to be low. A
voltage below this may result in a BATT transmission if configured.
On the ADC 1 and ADC 2 inputs this is the ADC count that the TReX ADC input is considered
to be low. An ADC count below this may result in an ADC input transmission if configured.
MSG LOW
The message that is transmitted when the input moves to the LOW level. Input messages must
always use WT Protocol.
© WTE Limited, 2022 – Christchurch New Zealand
Page 94 of 302
Summary of Contents for TReX-460
Page 87: ...TReX User Manual v15 30 Firmware WTE Limited 2022 Christchurch New Zealand Page 87 of 302...
Page 286: ...TReX User Manual v15 30 Firmware WTE Limited 2022 Christchurch New Zealand Page 286 of 302...
Page 302: ...TReX User Manual v15 30 Firmware WTE Limited 2022 Christchurch New Zealand Page 302 of 302...