WTE TReX-460, User Manual

Page: 51 / 302

TReX User Manual v15.30 Firmware
FREQUENCY
Specifies the transmit and receive frequency in Hz (range limited to the variant of product).
When RX is configured to DUPLEX, this setting may be independently configured for the
receiver.
MODULATION
Specifies modulation parameters. This includes whether the modulation is 2 or 4 levels GFSK
plus the channel width. 512_25 indicates 512 baud with 25kHz channel spacing (2 level
GFSK). 4800-4L_6 indicates 4800 baud with a 6.25kHz channel spacing (4 level GFSK).
Modulation rates from 512 baud to 32K baud can be set.
When RF is configured to DUPLEX, this setting may be independently configured for the
receiver.
MODE
Specifies the transport mode of the transmitter and receiver (how the information is received
over the air).
• POCSAG_A must be used in order to receive alphanumeric messages.
•
POCSAG_N must be used in order to receive numeric messages.
• POCSAG_T should be used in order to receive tone only messages.
•
WTE_EN must be used in order to receive 8 bit characters (POCSAG_A transmits 7
bit characters only).
When RF is configured to DUPLEX, this setting may be independently configured for the
receiver.
TX
Transmitter configuration items. Includes output power level, power limits and other TX only
parameters.
RX
Receiver configuration items. Includes RIC ranges, alerting options plus RF parameters such
as frequency when RF has been configured to be DUPLEX.
© WTE Limited, 2022 – Christchurch New Zealand
Page 51 of 302