WTE TReX-460, User Manual

Page: 95 / 302

TReX User Manual v15.30 Firmware
TX COUNT HI
If set to 0, then there will there will be NO transmissions when moving to the HIGH state. If
non-zero then this is the number of times the HIGH message will be transmitted.
If there is a change of state again, then any remaining transmissions are cancelled.
When set to a non-zero TX COUNT, the input level is considered to be ENABLED, and
displayed as ENABLED on the upper menu level.
ALLOW REM HI
If ENABLED then should multiple retransmissions be configured, if the input state changes to
LOW (that would normally cancel the remaining transmissions), the remaining HIGH
transmissions are allowed to complete in full.
RESEND HI
If not set to DISABLED, the interval specified is the time in seconds between repeating
retransmissions. This will resend the configured HIGH input level message indefinitely at this
interval (Only if the input level is HIGH).
RETX DELAY HI
How long in seconds before sending the next message if set to more than 1.
DEBOUNCE HI
How long in seconds that the input must be settled at a HIGH level before transmitting
THRESH HI
When configuring inputs 1-8, this field has no function.
On the BATT input this is the voltage that the TReX BATT input is considered to be high. A
voltage above this may result in a BATT transmission if configured.
On the ADC 1 and ADC 2 inputs this is the ADC count that the TReX ADC input is considered
to be HIGH. An ADC count above this may result in an ADC input transmission if configured.
Note: The BATT input threshold settings are also used to set the battery icon on the main
screens.
MSG HI
The message that is transmitted when the input moves to the HIGH level. Input messages must
always use WT Protocol.
© WTE Limited, 2022 – Christchurch New Zealand
Page 95 of 302