TReX User Manual v15.30 Firmware
Creating a SOLT Translation Table.
To allow transmitter translations, a file “SOLT.TXT” must be added to the TReX. In this file a
message must be associated with each transmitter ID and button. Hundreds of buttons can be
supported in this file. As the file increases to support thousands of transmitters, a small delay
before transmission may be observed.
Obtain the transmitter ID by pressing a SOLT transmitter button. There will be a screen pop-up
displaying the transmitter ID and button type. If the file SOLT.TXT is not present or the ID is
not found in that file, then the transmitter ID will also be sent out the serial port.
Default Serial Output Format:
WT
XXXXXXX
s
Y
0 SOLT ID:6748
Where:
XXXXXXX is the SOLT transmitter ID
Y is the SOLT button ID. Most SOLT transmitters will have an ID of 0. 6 button transmitters
will have a button ID from 1-6.
SOLT.TXT Content
<TX ID>:<BUTTON_NUM>,<WT Protocol message content>
6748:1,WT1234560A10 table 2 Bill
6748:2,WT1234560A10 table 2 Drinks
42679:1,WT0001001D60 Assistance required
All messages are specified in the WT protocol allowing for many pager types, DMR radios to
be supported (see
WT Protocol
). Also allows content to be redirected out the serial/TCP port.
© WTE Limited, 2022 – Christchurch New Zealand
Page 238 of 302
Summary of Contents for TReX-460
Page 87: ...TReX User Manual v15 30 Firmware WTE Limited 2022 Christchurch New Zealand Page 87 of 302...
Page 286: ...TReX User Manual v15 30 Firmware WTE Limited 2022 Christchurch New Zealand Page 286 of 302...
Page 302: ...TReX User Manual v15 30 Firmware WTE Limited 2022 Christchurch New Zealand Page 302 of 302...
