WTE TReX-460, User Manual

Page: 149 / 302

TReX User Manual v15.30 Firmware
To make the WT protocol use the database for either POCSAG or DMR, the following format
must be used:
WT 0000008 XXX<SPACE><MESSAGE><CR>
Using the digits 0000008 in place of a cap code or DMR code will make the protocol refer to
the database and transmit the given message to all recipients in either the RIC and/or DMR
database. It is important to note that only entries up to the first zero entry will be transmitted.
Any subsequent non-zero entries will be ignored. If there are no entries in the RIC DB, the
DMR DB will still be used if entries are present.
For example, to send a message to all recipients in the RIC and DMR database:
WT0000008 A10 <SPACE>TEST MESSAGE<CR>
The message “TEST MESSAGE” will be sent to each recipient in the RIC and DMR database.
Although “
A10 ” is specified, since the RIC database is being used, only MODULATION and
MODE is used that has been specified in the RF screen. If “ D60 ” is specified instead of “ A10 ”
behaviour will be the same.
When directed to send a DMR message, the transmission frequency, colour code and type will
be as configured in the DMR DB menu.
Note: DMR transmissions of any type, regardless of whether a DMR DB entry (forced by using
the 0000008 cap code), will always use the frequency specified by the DMR DB menu.
© WTE Limited, 2022 – Christchurch New Zealand
Page 149 of 302