11. Other information - Cleaning
Page 150
105204
– WTS-300-E - V4.1 - 20.01.2022
11.10 Service functions for testing the cleaning cycle
11.10.1
Start cleaning with the desired cleaning stage (0 to 8)
Set the desired cleaning stage (0 to 8) in parameter [r92].
Press CLEANING button: A cleaning cycle starts with the selected cleaning stage
and then runs through to the end.
The next cleaning cycle starts again with the first cleaning stage.
11.10.2
Single step function during cleaning
Advancing the cleaning cycle by individual steps
For a faster testing of the cleaning cycle, it is possible to manually switch the cycle
from one programme step to the next one with the single-step function, you do not
have to wait until it has been completely processed.
NOTE: Even a stopped cleaning cycle is considered completed!!
ATTENTION: The use of this single step function is at your own risk!
Advancing important processes poses a danger to both the tank and
the milk!
Proceed as follows:
either
Set in parameter [r93] how many cleaning cycles (1..3) should be carried out one
after another with the single step function.
NOTE: The single step function is immediately active when cleaning is started!
or permanently
Set selection '4' in parameter.
If '4' is selected, the single step function is started by pressing the CLEANING
button for 4 seconds while cleaning is in progress. StP' appears in the display.
By a repeated pressing the button CLEANING, the cycle can now be advanced
step by step.
NOTE:
The last rinsing step (n86) 'draining phase' cannot be skipped.
If cleaning has been continued via the single step function, the green LED 'CLEAN-
ING END' does not flash.
Cleaning can be stopped at any time by pressing the OFF button. A drain phase is
automatically carried out - this cannot be stopped. In the display, "ABL" appears
alternating with the temperature.
Programme step
WARNING
