Weh TK17 H2, Operating Instructions Manual

Page: 23 / 96

7�8 Optimization of fueling nozzle at a fueling station with a dispenser mounting
with integrated purging system (only TK17 H
2
with ENR)
If you are using a dispenser mounting with integrated purging system, proceed as follows:
Î Unscrew the three countersunk screws (Pos. 2) from the
impact protection sleeve (Pos. 1) using an hexagonal
screwdriver A/F2 ( Figure 6 ).
Î Remove the impact protection sleeve (Pos. 1) carefully
( Figure 7 ).
Attention: Do not apply high radial torque to the impact
protection sleeve during disassembly!
Slight rotary movements are allowable during
disassembly.
Î
Remove the two plugs with a flat slotted screwdriver
( Figure 8 ). This clears the three 'drain holes' for purging.
Attention: The components may not be damaged!
Î Then attach the impact protection sleeve (Pos. 1) back
onto the fueling nozzle.
Note: The hole pattern of the impact protection sleeve
must be aligned with the counterpart!
Attention: When fitting the impact protection sleeve, do
not apply any strong radial torque to it! Slight rotary
movements for adjustment are allowable during assembly.
Î Fix the impact protection sleeve (Pos. 1) with the three
countersunk screws (Pos. 2).
Tightening torque 1.5 Nm.
Figure 6
Pos. 1
Pos. 2
Pos. 1
Figure 7
Figure 8
Plug
MD-10013-L51-R1.6.0-03
Page 23
Operating instructions AE