9�4�3
Replacing the logo cap (Pos� 3)
Î
Remove the
logo cap (Pos. 3) laterally
from the label plate.
Î
Align the new
logo cap (Pos. 3) straight and
press it into the openings of
the label plate.
9�4�4
Assembly of logo cap including label plate (Pos� 3)
Please note:
The label plate is glued to the handle protection and cannot be removed.
Should the label plate come loose or break, however (e.g. due to the nozzle falling to the
ground), a new label plate can be affixed to the handle protection.
Î
Apply a thin layer of
WEH
®
Adhesive,
Part No. E99-35,
to the three areas marked
in red in the groove on the
handle protection.
Î
Press the new label plate
including logo cap (Pos. 3)
onto the handle protection.
Please note:
The pin of the
handle protection and the
recess of the label plate must
interlock.
Recess
Pin
MD-10013-L51-R1.6.0-03
Page 32
Operating instructions
AE
Summary of Contents for TK17 H2
Page 2: ......
