Weh TK17 H2, Operating Instructions Manual

Page: 22 / 96

7�5 Connection of data cable (only TK17 H
2
with ENR)
Î
Pull off the protection cap from the data cable connector
(Pos. 8).
Î Connect the interface cable.
Tightening torque 1 Nm.
Attention: The guiding pin of the data cable connector
must engage in the groove of the interface cable
connector ( Figure 2 and Figure 3 ).
Please note: For torque tightening, the WEH
®
Assembly
tool part no. 148012 can be used.
7�6 Check of data interface function (Pos� 9)
Î Check the data interface (Pos. 9) for correct functioning.
7�7 Installation of braided protection hose
Î
Unscrew the cold protection (plastic thermal protection)
from the swivel joint (Pos. 4) and remove it from the
fueling nozzle.
Î Pull the cold protection (plastic thermal protection) over the
prepared braided protection hose ( Figure 4 ).
Î Pull the braided protection hose over the
swivel joint (Pos. 4) ( Figure 5 ).
Î
Slide the cold protection (plastic thermal protection) over
the braided protection hose onto the
swivel joint (Pos. 4) and screw down the cold protection
(plastic thermal protection).
Figure 2
Guiding pin
Figure 3
Groove
Figure 4
Figure 5
MD-10013-L51-R1.6.0-03
Page 22
Operating instructions AE