waratah FL85, Operator'S Manual

Page: 48 / 80

Maintenance: Initial Set-up
AM24480,0000352 -19-06SEP21-3/3
AM24480,0000353 -19-06SEP21-1/1
6. Attach gauge JT05473 (5) to the saw bar travel port (4);
ensure the gauge is visible from the operator’s seat.
7. Start the carrier and operate the saw function.
IMPORTANT: Be aware that the saw motor will be
damaged; only operate the saw function during
the test. If the saw motor
is damaged, you
must repair or replace it as required.
8. Ensure the saw bar travel pressure is within
specification.
Specification
Saw bar travel pressure ............................................ 5 000—5 500 kPa
50—55 bar
725—800 psi
9. Shut down the carrier.
CAUTION: As the felling head can move or
function unexpectedly, you should always make
sure the carrier is completely shut down, with
the felling head placed securely on flat, level
ground. Failing to follow this process can
increase the risk of serious injury or death.
10. Remove the gauge (5).
4
5
TX1045004
—UN—02JUL08
4— Saw bar travel port 5— Gauge
11. Re-install the fitting (2) and hose (3).
12. Re-install the saw cover (1).
Adjust the saw bar travel limiter
1. The length of saw bar travel limiter (A) is pre-set to
specification.
Specification
Saw bar travel limiter
length
............................................................ 631 mm
24.84”
2. Loosen the nuts (3) on the limiter.
3. Increase or decrease the length of the saw bar travel
limiter, setting it to within specification. Increasing this
length will increase the size of the saw bar’s swing;
reducing this length will decrease the size of the saw
bar swing.
Specification
Range of the saw bar
travel limiter length
...................................................616—641 mm
24.25—25.25”
4. Re-tighten the nuts (3).
1
3
2
3
A
TX1044821
—UN—27JUN08
1— Saw bar travel limiter
2— Saw bar travel limiter
Adjuster
3— Nut (x2)
A—631 mm (24.84”)
3-2-5 090621
PN=48