Sound Parameter
62
Quantum Manual
Timbre
Based on the
Timbre
Mode
on the Resonator display page,
this parameter changes the structure of the partials. In
some cases this works similar to a filter, which cuts off
partials. In other cases the partials are emphasized.
Exciter
Determines the sound of the exciter signal. Fully counter-
clockwise, a short impulse is generated while higher set-
tings fade this impulse into a short noise. Use higher set-
tings when you want to simulate the blowing sound of a
wind instrument. If a loaded sample is used as exciter, this
parameter influences how the sample sounds.
r
For more information about loading and editing
samples, please refer to ‘The Loading & Editing
Samples’ chapter.
Q
Determines the resonance of the created partials. The
higher the setting, the longer the duration of the created
sounds.
Resonator Display Page
To access the Resonator display page, press the corres-
ponding OSC 1, 2, or 3 button above the touchscreen dis-
play.
Here you can change between two modes:
Control
and
Timbre
. Tap on the corresponding tab to select it. The
display changes to this mode. A third tab displays the cur-
rent oscillator model. Tap on it to select another model or
switch it off.
Control Mode Tab
Here you find parameters relating to the tuning and some
basic settings. The functions are the same as for the Wave-
table generator. Please refer to the corresponding chapter.
Timbre Mode Tab
Here you find specific parameters for the Resonator.
Summary of Contents for QUANTUM
Page 1: ...USER MANUAL...