Wacker Neuson 5000620172, Operator'S Manual

Page: 62 / 162

wc_tx001903gb.fm
62
Operation E 1100
Continued from the previous page.
6. Lift and hold the HTF fill switch (b) in the ON position and watch the HTF
reservoir sightglass (c) —release the HTF fill switch when the HTF level is at the
minimum level in the HTF reservoir sightglass.
NOTICE: Do not overfill the HTF reservoir. Doing so may damage the machine.
7. Press and release the “RESET” button (d) on the low-level shut-down device.
The following will occur:
„
The “POWER” (green) (f) and “LOW WATER” (red) (e) lights will blink for fif-
teen seconds while the low-level shut-down device performs a self-diagnos-
tic test.
„
After 15 seconds, the “LOW WATER” light will go out—the “POWER” light will
stay on.
„
The low HTF level indicator will go out.
„
Power will be returned to the pumps.
„
Power will be returned to the burner.
8. Move the pump ON-OFF switch to the ON position and continue to fill the HTF
reservoir until the HTF level is between the two marks on the HTF reservoir
sightglass.
NOTICE: Do not overfill the HTF reservoir. Doing so may damage the machine.
9. Move valve #2 to the normal position.
10.Remove the fill hose from the HTF container and allow any HTF within the hose
to drip back into the container. Cap the fill hose if a cap is provided.
11.Move the fill hose to its storage location under the hose reel.
Result The low HTF level fault has been reset and the HTF reservoir has now been filled.
You may now resume operation of the machine.