VTS Medical Systems WING C100, Technical Documentation Manual

Page: 29 / 236

29
EN
IMPORTANT! While venting the exchanger you should pay special attention to securing the device against accidental penetration of water into electrical elements.
IMPORTANT! Remember to vent the heater, if it has been activated after a prior draining of the heating medium.
IMPORTANT! 3D\SDUWLFXODUDWWHQWLRQWRWKHOHDNWLJKWQHVVRIFRQQHFWLRQVZKHQ¿OLQJWKHK\GUDXOLFV\VWHP0DNHVXUHWKDWWKHZDWHUÀRZLQJIURPDOHDN\FRQQHFWLRQGRHVQRWOHDNWRWKH
electric engine (at the vertical assembly).
CONNECTING OF POWER SUPPLY
IMPORTANT! The system must be equipped with protective equipment that guarantees the disconnecting of the device on all poles of the power source.
&RQQHFWLRQWRWKHHOHFWULFV\VWHPPXVWEHSHUIRUPHGE\DGXO\DXWKRUL]HGDQGTXDOL¿HGSHUVRQ:LUHSDVVHVDUHORFDWHGRQWKHEDFNVLGHRIWKHFXUWDLQ±FRQWUROZLUHSDFNLQJ±SRZHU
wire packing. The access to the terminal strip is obtained by means of removing the outlet grid (3) from the motor's side. It is required to mount the cable strain relief (5), to protect the cable (4)
against pulling.
VENTING OF DEVICE/DRAINING OF HEATING MEDIUM
Ventin of the curtain water coil followed by loosening the union connection on the outlet connection. In case of the vertical assembly with the coils connection on the bottom side, the acces to
the vent valve is by removing the side cover. To do it one should remove the screws (1) around the cover and remove the cover. There is a valve (2) with a hose.
1
2
3
WORKING POSITION
VENT/DRAIN MARKING
2 3
A
horizontal (downward air feed) drain automatic venting
B
vertical (air feed from left to right) drain automatic venting
C
vertical (air feed from right to left venting drain
1
2
3
4
4
5
5