- 50 -
C1453
01000.
fm
English
Maintenance information
GB
D700/750 E2-E3
Follow the procedure below.
1-
Start the engine and run it at
minimum speed for a few minutes.
The cooling circuit reaches the op-
erating pressure.
2-
Turn off the engine and remove
the ignition key.
3-
Let the engine cool down ade-
quately to avoid being burnt.
4-
Prepare a container of appro-
priate capacity.
As for the liquid quantity, see
"Technical data".
5-
Unscrew the load plug
(P)
.
Warning - Caution
Open the plug gently to drain the
pressure.
6-
Open the cock
(S)
.
Important
– In the absence of a coolant discharge
tap, check for the presence of a dis-
charge plug or loosen one of the cooling
circuit clamps in the lower part of the
cooler.
– For further information, please con-
sult the documentation provided by the
manufacturer of the vehicle/device in
which the engine is installed.
7-
Let the liquid flow into the container.
8-
Close the cock
(S)
.
9-
Pour in the new liquid.
Important
– The fluid level must be up to the base
of the neck into which the radiator plug is
screwed.
– If there is a coolant expansion tank,
consult the documentation provided by
the manufacturer of the vehicle/device in
which the engine is installed.
– As for the liquid quantity and type, see
"Technical data".
10-
Screw again the plug
(P)
.
COOLANT REPLACEMENT
IDM-45300901500.tif
Filler cap
(P)
Tap
(S)