VIPA CP 240 RS232, Manual

Page: 70 / 148

Chapter 4 CP 240 - serial Manual VIPA System 200V
4-24 HB97E - CP - Rev. 11/30
The delay time that must expire before a command is executed. The ZNA
is specified in units of 20ms.
Range: 0 ... 255 Default: 0
The character delay time defines the maximum time that may expire
between two characters of a single messages during the reception of the
message. The ZVZ is defined in units of 20ms.
When the ZVZ=0 the character delay time (ZVZ) will be calculated
automatically (about double character time).
Range: 0 ... 255 Default: 10
Defines the number of receive buffers. When only 1 receive buffer is
available no more data can be received while the receive buffer is
occupied. The received data can be redirected into an unused receive
buffer when you chain up to a maximum of 250 receive buffers.
Range: 1 ... 250 Default: 1
TMO defines the maximum time between two messages. TMO is specified
in units of 20ms.
Range: 1 ... 255 Default: 10
You can select 1 or 2 start flags. When you select "1" as number of start
flags, the contents of the 2
nd
start flag (byte 8) is ignored.
Range: 0 ... 2 Default: 1
The ASCII value of the start character that precedes a message to signify
the start of a data transfer. You may select 1 or 2 start characters. When
you are using 2 start characters you have to specify "2" at "Number of start
flags ".
Start character 1, 2: Range: 0 ... 255 Default: 2 (char. 1)
0 (char. 2)
You can select 1 or 2 end flags. When you select "1" as number of end
flags, the contents of the 2
nd
end flag (byte 11) is ignored.
Range: 0 ... 2 Default: 1
The ASCII value of the end character that follows a message to signify the
end of the data transfer. You may specify 1 or 2 end characters. When you
are using 2 end characters you have to enter a "2" for "number of end
flags".
End character 1, 2: Range: 0 ... 255 Default: 3 (char. 1)
0 (char. 2)
Time delay after
command (ZNA)
Character delay
time (ZVZ)
(for ASCII, 3964(R) and
RK512)
Number of receive
buffers
(
only for ASCII)
Timeout (TMO)
(only for STX/ETX)
Number of start
flags
(only for STX/ETX)
Start flag 1 and 2
(STX)
(only for STX/ETX)
Number of end
flags
(only for STX/ETX)
End flag 1 and 2
(ETX)
(only for STX/ETX)