Manual VIPA System 200V
Chapter 4 CP 240 - serial
HB97E - CP - Rev. 11/30
4-41
The project has the following structure:
The sample already contains the PLC program and the parameters for the
Modbus master. you only need to adjust the Modbus parameters.
For this start the hardware configurator and choose the module 240-
1CA20. Via double-click you reach the parameterization:
Dialog for address entry
Here you may set from which address on the
16Byte for in- and output are stored in the CPU.
Please regard that you have to change the
addresses that you are changing here also in
the SEND and RECEIVE blocks.
Dialog for Modbus parameters
In this section of the parameterization you set
the Modbus parameters.
The following parameters must be identical for
all bus participants: baud rate, data Bits, parity,
stop bits and flow control.
Set “Modbus Master RTU” in
Protocol
.
The setting of an address is only required at
slave side.
At a master parameterization the address is
ignored.
Project structure
Master project
engineering
Parameterization
Summary of Contents for CP 240 RS232
