Viking MI 632, Instruction Manual

Page: 128 / 428

0478 131 9931 B - EN
126
In the case of medium
sensitivity , the robotic
mower is ready for operation
under normal ambient
conditions.
Move the bar further to the
left for mowing at a higher
humidity. If the bar is moved
all the way to the left, the
robotic mower will mow even
in wet external conditions and will not
interrupt the mowing operation if rain drops
land on the sensor.
Move the bar further to the
right for mowing at a lower
humidity. If the bar is moved
all the way to the right, the
robotic mower will only mow if
the rain sensor is completely dry.
11.13 Setting the status screen
In order to configure the status screen,
select the left or right screen with the
control pad and confirm with OK.
Charge state :
Shows the battery symbol with the
charge state in percent
Rem. time :
The remaining mowing duration
during the current week in hours and
minutes
Time and date :
Current date and current time
Start time :
Start of the next planned mowing
operation. During a running active
time, the text "active" is displayed.
Mowing ops :
Total number of mowing operations
performed
Mowing hours :
Total duration of all mowing
operations performed
Distance :
Total distance covered
GPRS reception
(MI 632 C, MI 632 PC):
Signal strength of the mobile radio
connection with network ID. A small
x or question mark indicates that the
robotic mower is not connected to
the Internet. (
Ö 11.3), ( Ö 11.9)
GPS reception
(MI 632 C, MI 632 PC):
GPS coordinates of the robotic
mower. (
Ö 11.9)
11.14 Installation
1. Corridor:
Switching offset drive home on and off.
When the corridor is activated, the robotic
mower travels back home to the docking
station, offset at a distance, along the
perimeter wire.
Corridor width:
30-70 cm
The distance to the perimeter wire within
this corridor is selected randomly.
2. New installation:
The installation assistant is started
again and the existing mowing plan
is deleted. (
Ö 9.4)
3. Starting points:
The robotic mower either starts the
mowing operations at the docking
station (default setting) or at a starting
point.
Starting points are to be defined
– if partial areas are to be travelled to in a
targeted manner because they are
insufficiently mowed,
– if areas can only be accessed via a
corridor. At least one starting point must
be defined in these partial areas.
MI 632 C, MI 632 PC:
The starting points can be assigned a
radius . If the robotic mower starts mowing
at the relevant starting point, it always
mows within a circle around the starting
point first. Once it has mown this partial
area, it continues mowing in the remaining
area.
● Setting starting points ( Ö 11.15)
4. Edge testing:
Start the test run for checking
correct wire routing.
The step "Check installation" of the
installation assistant is called up. (
Ö 9.9)
In conjunction with an external
docking station, a separately
available accessory is required for
offset drive home (
AED 600 ).
More information can be obtained
from your VIKING dealer.
Offset drive home can only be
activated when the perimeter wire
has been routed with a clearance of
at least 2 m at the narrowest
sections. No corridors may be
installed within the mowing area.