Viking MI 632, Instruction Manual

Page: 117 / 428

115
DE
FR
NL
IT
EN
0478 131 9931 B - EN
The distance covered is shown on the
display – this metric specification is
required for setting
starting points at the
edge of the mowing area. ( Ö 11.15)
● Read the displayed value at the
required location and write it down.
Manually set starting points after initial
installation.
The following of edges is automatically
interrupted by obstacles, during operation
on excessively steep slopes or by pressing
the STOP button.
● If the test run has been interrupted
automatically, correct the position of the
perimeter wire and remove any
obstacles.
● Check the position of the robotic mower
before continuing edge following. The
machine must either be located on the
perimeter wire or within the mowing
area with the front facing the perimeter
wire.
Continuation following interruption:
After an interruption, continue edge
following with
Yes .
No ends the following of the perimeter wire
and the next step of the installation
assistant is called up.
Completion of the test run:
The next step of the installation assistant is
called up when the robotic mower docks
following a complete circuit.
9.10 Programming the robotic mower
Enter the size of the lawn and
confirm with OK.
A new mowing plan is calculated.
The procedure can be aborted using the
red STOP button on the top of the
machine.
Confirm the message "Confirm each
day individually or change active
time" by pressing the OK button.
VIKING recommends that the test
run is not interrupted. Possible
problems when following the edge
of the mowing area or when
docking may not be recognised.
The test run can be repeated
following initial installation if
necessary. (
Ö 11.14)
Installed no-go areas and
secondary areas must not be
included when calculating the size
of the mowing area.