Viking MI 632, Instruction Manual

Page: 110 / 428

0478 131 9931 B - EN
108
Connect the connector of the
power supply unit (1) to plug
connection (2) of the docking
station circuit board.
Guide the power cable as illustrated
through the strain relief (1), through the
cable duct (2) and to the power supply
unit.
● Install the power supply unit outside the
mowing area, protected from direct
sunlight, humidity and moisture – fasten
to a wall if necessary.
● Route all power cables outside the
mowing area, in particular out of reach
of the mowing blade, and fasten them to
the ground or accommodate in a cable
duct.
● Unreel power cables in the vicinity of
the docking station in order to avoid
interference with the wire signal.
Fit the cover (1) onto the
docking station and allow it to
engage – do not pinch any
cables. Then connect the mains
plug.
● After completing this installation
work, press the OK button on the
control panel.
Lift the robotic mower slightly by the carry
handle (1) to relieve the weight on the
drive wheels. Push the machine, resting
on its front wheels, into the docking
station.
No LED must illuminate on the docking
station after docking. (
Ö 13.1)
If necessary, the connector can be
removed (e.g. in order to route the
power cable through a hole in a
wall).
Make sure that the polarity is
correct when attaching the
connector to the power cable.
(
Ö 16.8)
Correct operation of the power
supply unit is only ensured at an
operating temperature between
0° C and 60° C .
The red LED on the docking station
flashes as long as no perimeter
wire is connected. (
Ö 13.1)
If an external docking station has
been installed, VIKING
recommends defining at least one
starting point outside the corridor to
the docking station after initial
installation is complete. The starting
frequency should be defined so that
0 of 10 mowing operations (0/10)
are started at the docking station
(starting point 0). (
Ö 11.15)