Viking MI 632, Instruction Manual

Page: 112 / 428

0478 131 9931 B - EN
110
External docking station:
Route the perimeter wire (2) in front of and
behind the docking station (1) with a
clearance (A) and at right angles to the
floor plate. Then install a corridor. (
Ö 12.9)
A freely travellable minimum clearance (B)
must be available for the robotic mower to
the side of the ground plate.
A = 50 cm
B = 44 cm
Then follow the edge of the mowing area
with the perimeter wire.
Route the perimeter wire (1) around the
mowing area and around any obstacles
(
Ö 12.7) and fasten it to the ground using
fixing pins (2). Check the clearances using
the iRuler. (
Ö 12.5)
A greater wire clearance must be
maintained at the corners around high
obstacles such as wall corners or high
flowerbeds
X to prevent the robotic
mower from scraping against the obstacle.
Route the perimeter wire (1) with the aid of
the iRuler (2) as shown.
Avoid routing at acute angles (less than
90°). In acutely angled lawn corners,
fasten the perimeter wire (1) to the ground
with fixing pins (2) as illustrated.
● If necessary, extend the perimeter wire
using the wire connectors supplied.
(
Ö 12.14)
● In the case of several adjacent mowing
areas, install secondary areas (
Ö 12.8)
or join the mowing areas with corridors.
(
Ö 12.9)
Further information on installation
of the external docking station is
contained in the Installation
examples section. (
Ö
27.)