Viking MI 632, Instruction Manual

Page: 133 / 428

131
DE
FR
NL
IT
EN
0478 131 9931 B - EN
12.4 Connecting the perimeter wire
● Disconnect the mains plug
and then remove the docking
station cover.
● Insert the perimeter wire into the cable
guides of the floor plate, guide it
through the socket, attach the
connector and connect to the docking
station.
Follow the instructions in the "Initial
installation" section. (
Ö 9.7)
● Install the docking station
cover and then connect the
mains plug.
● Check the wire signal. ( Ö 13.1)
● Check docking. ( Ö 15.7)
If necessary, correct the position of the
perimeter wire in the area of the
docking station.
12.5 Wire clearances – use iRuler
The perimeter wire (1) can be routed
without clearance along obstacles that
can be travelled on such as patios and
paths. The robotic mower then travels with
one rear wheel outside the mowing area.
Maximum height difference between lawn
area and obstacle: 2 cm
Measuring wire clearances with the
iRuler:
To ensure the correct clearance from the
perimeter wire to the edge of the lawn and
to obstacles, the iRuler should be used for
measuring the distances.
A – 10 cm
Increased clearance for routing
the perimeter wire around an
external corner at a high
obstacle. (
Ö 9.6)
Wire clearance for funnel-
shaped routing of the perimeter
wire at the start and end of a
corridor. (
Ö 12.9)
B – 17 cm
Wire clearance for funnel-
shaped routing of the perimeter
wire at the start and end of a
corridor. (
Ö 12.9)
C – 27 cm
Wire clearance in corridors.
Corridors serve to connect
several mowing areas or for bridging
confined areas. (
Ö 12.9)
Distance between an obstacle
and the perimeter wire.
The robotic mower must run completely
within the mowing area and must not touch
the obstacle.
The minimum clearance between wires in
confined areas is double the distance of
C (54 cm, of 2 iRuler lengths or the
machine width.) ( Ö 12.6)
D – 2 cm
Measure the height of
obstacles. The robotic mower
can cross low obstacles such as
paths if the stepped area is not too high.
The step in the iRuler corresponds
precisely to this height.
Take care not to damage the
perimeter wire when tending to the
lawn edge. If necessary, install the
perimeter wire at a slight distance
(2-3 cm) from the lawn edge.