Viking MI 632, Instruction Manual

Page: 140 / 428

0478 131 9931 B - EN
138
14.3 Active times
During the active times, the robotic mower
is allowed to leave the docking station and
mow the lawn. During these times,
mowing operations , charging
operations and rest periods take place.
The robotic mower automatically
distributes the mowing and charging
operations between the available time
windows.
During installation, active times are
automatically distributed over the entire
week. Time reserves are taken into
account – this ensures perfect lawn care,
even if individual mowing operations
cannot take place, (e.g. due to rain).
14.4 Mowing duration
The mowing duration specifies how many
hours per week the lawn is to be mown. It
can be extended or reduced in the weekly
settings (
Ö 11.8).
The mowing duration corresponds to the
time during which the robotic mower mows
the lawn. Times during which the battery is
charged are not part of the mowing
duration.
During initial installation, the robotic
mower automatically calculates the
mowing duration based on the specified
size of the mowing area. This reference
value is based on a normal lawn under dry
conditions.
Mowing performance:
For 100 m
2
, the robotic mower needs on
average:
14.5 Home area (MI 632 C, MI 632 PC)
The robotic mower identifies its location
using the built-in GPS receiver. During
each test run to check the correct wire
routing (
Ö 9.9) and when entering in the
starting points ( Ö 11.15), the robotic
mower stores the coordinates of the most
westerly, easterly, southerly and northerly
point.
This area is defined as the home area and
the robotic mower can be used here. The
coordinates are updated each time a test
run is repeated.
If the robotic mower is removed from the
home area when
GPS protection is
activated, the registered owner is notified
by SMS and e-mail and the PIN code is
requested on the robotic mower display.
14.6 Manual mowing
Do not activate the mowing blade or set
the lowest cutting height in high grass.
The robotic mower load must never cause
the mowing motor speed to drop
significantly. If the speed drops or the
robotic mower slows down, select a higher
cutting height setting.
15.1 Preparation
● Install the docking station ( Ö 9.5)
● Route the perimeter wire ( Ö 9.6) and
connect ( Ö 9.7)
● Remove foreign bodies (e.g. toys,
tools) from the mowing area.
● Charge the battery ( Ö 15.8)
● Set the time and date ( Ö 11.11)
● Check the mowing plan and adapt if
necessary – in particular it must be
ensured that third parties keep away
from the danger area during active
times. (
Ö 11.6)
During the active times, third
parties must keep out of the danger
area. The active times should be
adapted accordingly.
Moreover, the applicable local
regulations on the use of robotic
mowers as well as the information
in the "For your safety"
section (
Ö 6.) must be observed
and the active times changed
accordingly in the "Mowing plan"
menu as required. (
Ö 11.7)
In particular, you should check the
times of the day and night at which
it is permissible to use the machine
with the responsible authorities.
MI 632, MI 632 C: 70 minutes
MI 632 P, MI 632 PC: 60 minutes
15. Operating the machine
An installation assistant is available
for
initial installation . ( Ö 9.)
Mow very high grass until it is short
using a conventional lawn mower
prior to use of the robotic mower
(e.g following a lengthy break).