Vicon Surveyor 99, Installation & Operation Manual

Page: 47 / 69

XX002 Rev 799 Surveyor99 Dome System Wiring
••••
37
WARNING: Connectors TB3 and J3 contain the same control signals. Therefore, wire the control cable to
TB3 OR J3, not both, to avoid communication errors.
WARNING: If Vicoax mode is being used, DO NOT wire TB3 or J3 for control, as this will cause the
Camera Dome Program to lock up upon power-up.
CONNECTOR/PIN
NUMBER
CONNECTOR TYPE CONNECTOR/PIN LABEL SIGNAL NAME
BNC (female) VIDEO (J1)
J1
VIDEO
Video output
TERMINAL BLOCK POWER (TB1)
TB1-1
H
Hot
TB1-2 N Neutral
TB1-3 No connection
RJ-45 ALARM (J2)
J2-1
ALARM1
Alarm input 1
J2-2 VSSA Ground
J2-3
ALARM2
Alarm input 2
J2-4 VSSA Ground
J2-5
ALARM3
Alarm input 3
J2-6 VSSA Ground
J2-7
ALARM4
Alarm input 4
J2-8
VSSA
Ground
TERMINAL BLOCK
COMM (TB3)
TB3-1 VSSA Ground
TB3-2 RO+ Response out +
TB3-3 CI- Command in -
TB3-4 RO- Response out -
TB3-5
CI+
Command in +
RJ-45 COMM/RELAY (J3)
J3-1 CI+ Command in +
J3-2 RELAY NC Relay, normally closed
J3-3
VSSA
Ground
J3-4 RO- Response out -
J3-5
CI-
Command in -
J3-6 RELAY C Relay, common
J3-7
RELAY NO
Relay, normally open
J3-8
RO+
Response out +
Table 1
Communication/Power Supply Board Connector Definitions