Vicon Surveyor 99, Installation & Operation Manual

Page: 35 / 69

XX002 Rev 799 Surveyor99 Dome System Installation
••••
25
OUTDOOR PENDANT MODEL
The Outdoor Pendant Model mounts on a Vicon Mount or a 1.0-inch vertical Pipe in the same manner as the
Indoor version. The Outdoor version includes a Sunshield, Heater and weather protection.
The Mount is installed with all the cables run through it and the 1.0-inch NPT Pipe is prepared with Teflon
Tape for the Housing and the Surveyor99 installation. The cables are routed through the Housing and the
Housing is screwed tightly to the pipe. Then the Surveyor99 is hung from the Housing Safety Cord while it is
wired and configured. The Surveyor99 is then carefully snapped into the Housing. The entire Surveyor99 is
supported by the Mount. The Indoor Lower Dome is then anchored with its Safety Cord, snapped on and
screwed tight to the Surveyor99. See Figure 23. Detailed installation instructions will follow.
The Accessory Kit containing the RJ-45 to RJ-45 8 foot (2.4 m) cable and RJ-45 Termination Box can be used
for wiring the 4 alarms or the relay in this installation. Since the supplied cable is limited to 8 feet (2.4 m), the
Termination Box must be mounted within the immediate area of the Surveyor99.
The Mount must provide a support of suitable strength for the Sunshield, Housing and the Surveyor99 weight
of 6.8 lb (3.0 kg).
1. Install the Mount in accordance with the
Installation Manual included with the Mount or
prepare the vertical 1.0-inch NPT Pipe.
2. Feed all necessary cables through the back of
the Mount and out the end of the 1.0-inch NPT
Pipe, 16-inches (406 mm) in length.
3. Lift the Sunshield and Housing up to the Mount
and feed the cables through its top opening.
4. Tightly wrap approximately 3 turns of supplied
Teflon Tape clockwise around pipe, looking up
at the pipe.
NOTE: Failure to apply the tape to the threads will
result in moisture entering the Housing and
eventual failure of the Surveyor99.
5. Place the Housing onto the 1.0-inch pipe and
screw clockwise, looking up at the Housing.
When it becomes snug, turn it an additional
quarter-turn.
6. Verify that each cable drops from the pipe
opening at least 16-inches (406 mm) in length.
7. Lift the Surveyor99 up to the Housing and attach the Housing’s Safety Cord to the Surveyor99’s Latch.
Allow the Surveyor99 to hang from the Housing.
Figure 23
Outdoor Pendant Mount Model