Vicon Surveyor 99, Installation & Operation Manual

Page: 34 / 69

24
••••
Installation XX002 Rev 799 Surveyor99 Dome System
2. Set switch 2 on DIP Switch 2 (S2) to the ON position (Vicoax mode).
3. Set switch 3 on DIP Switch 2 (S2) to either position, as it does not affect Vicoax protocol
operation.
4. Set switch 4 on DIP Switch 2 (S2) to either position, as it does not affect Vicoax protocol
operation.
NOTE: DIP Switches labeled ON or CLOSED and OFF or OPEN have the same meaning.
14. With the Surveyor99 hanging from the Housing, verify that the wiring resembles
the technique of Figure 21a.
WARNING: Cables having excessive slack can cause damage to the
Surveyor99 when installed into the Housing.
15. With the Surveyor99 oriented as shown in Figure 21b, lift it so that it is flush
with the Housing.
16. Turn the Surveyor99 counterclockwise (looking up) until the arrow on the
Installation Label is aligned with the arrow on the inside of the Housing as
shown in Figures 21c and 21d.
17. Push the Surveyor99 straight up into the Housing as shown in Figure 21e.
Verify that the 2 slots on the Surveyor99 snap into the Housing clips. Do not
use excessive force. In the event that it does not snap easily, remove the
Surveyor99 and verify proper cabling.
13. Lift the Lower Dome up to the
Surveyor99 and press in it’s Safety
Cord Plug into the hole provided on
the inside of the Enclosure to
anchor the Lower Dome. See
Figure 22.
14. Holding the Lower Dome, line up
the 2 molded tabs on the Lower
Dome with the 2 recesses on the
inner Enclosure. There are only 2
ways to align it. Push the Lower
Dome up and verify that it snaps
into place on both sides.
15. Proceed to the Operation Section of
this manual.
a
b
c
d
e
Figure 21
Pendant Mount Final
Assembly
Figure 22
Indoor Lower Dome Installation