XX002 Rev 799 Surveyor99 Dome System
Installation
••••
27
4. Set switch 3 on DIP Switch 2 (S2) to the OFF position (SIMPLEX/DUPLEX).
5. Set switch 4 on DIP Switch 2 (S2) to the appropriate communication protocol (RS-422 or RS-485).
b) If Vicoax Mode will be used:
1. Set switch 1 on DIP Switch 2 (S2) to the appropriate video mode (PAL or
NTSC).
2. Set switch 2 on DIP Switch 2 (S2) to the ON position (Vicoax mode).
3. Set switches 3 and 4 on DIP Switch 2 (S2) to either position, as they do
not affect Vicoax protocol operation.
NOTE: DIP Switches labeled ON or CLOSED and OFF or OPEN have the same
meaning.
15. With the Surveyor99 hanging from the Housing, verify that the wiring resembles
the technique of Figure 24a.
WARNING: Cables having excessive slack can cause damage to the Surveyor99
when installed into the Housing.
16. With the Surveyor99 oriented as shown in Figure 24b, lift it so that it is flush with
the Housing.
17. Turn the Surveyor99 counterclockwise (looking up) until the arrow on the
Installation Label is aligned with the arrow on the inside of the Housing as shown
in Figures 24b and 24c.
18. Push the Surveyor99 straight up into the Housing as shown in Figure 24d. Verify
that the 2 slots on the Surveyor99 snap into the Housing clips. Do not use
excessive force. In the event that it does not snap easily, remove the Surveyor99
and verify proper cabling.
19. Lift the Lower Dome up to the Surveyor99 and press in its Safety Cord Plug into
the hole provided on the inside of the Enclosure to anchor the Lower Dome.
19. Holding the Lower Dome, line up the 2
molded tabs on the Lower Dome with
the 2 recesses on the inner Enclosure.
There are only 2 ways to align it. Push
the Lower Dome up and verify that it
snaps into place on both sides. See
Figure 25.
20. Tighten the 4 Trim Ring Screws to hold
the Lower Dome in place. Verify proper
orientation of the Grommet.
21. Proceed to the Operation Section of this
manual.
a
b
c
d
Figure 24
Pendant Mount
Final Assembly
Figure 25
Outdoor Lower Dome Installation
Summary of Contents for Surveyor 99
