Vicon RV 4116, Operation And Maintenance Manual

Page: 91 / 192

2
17-211-1.
fm
ID
M
English
- 85 -
▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬ Failure information
Part 3
The twine guiding arms
are not positioned
correctly.
The transmission chain is
dirty.
Clean using compressed
air and re-position the
right twine guiding arm. See "How to adjust the
twine guiding arm chains"
in part 7
The transmission chain is
worn.
Get the chain repaired or
replaced by the nearest
authorized Technical
Assistance Centre.
Faulty potentiometer
Get the potentiometer
repaired or replaced by
the nearest authorized
Technical Assistance
Centre.
The twine guiding arms
do not move.
Blown fuse Replace the fuse
Damaged electric motor
Get the motor repaired or
replaced by the nearest
authorized Assistance
centre.
One or both twines are
not drawn by the bale at
the start of the binding
operation.
The twine is not
assembled correctly
Assemble the twine
according to the correct
path.
see "How to introduce the
twine" in booklet 7
Twine braking is
excessive. Adjust the twine
tightening clamps.
see "How to adjust the
twine tightening clamps"
in booklet 7
The twine does not
sufficiently go out of the
twine guiding arm Make the twine go out of
the twine guiding arm of
about 25÷30 cm.
see "How to introduce the
twine" in booklet 7
The binding element
introduction unit does not
operate
Check and contact a
Technical Assistance
Centre that is authorised
by the Manufacturer
The machine has run out
of twine reels Supply twine reels into the
twine case. see "How to supply the
twine reels" in booklet 7
Twine binding is not
performed.
The machine has run out
of twine reels Supply twine reels into the
twine case. see "How to supply the
twine reels" in booklet 7
The knot that joints the
twine reels was not
performed correctly. Check the joint knots and,
if necessary, knot them
again.
see "How to supply the
twine reels" in booklet 7
The cutting arm was not
adjusted correctly
Check and contact a
Technical Assistance
Centre that is authorised
by the Manufacturer
The twine is not cut
correctly
Cutting blades are worn.
Sharpen the blades or
replace them
see "How to replace the
blades" in booklet 7
Important
Wear protective gloves
for this operation.
The cutting arm was not
adjusted correctly
Check and contact a
Technical Assistance
Centre that is authorised
by the Manufacturer
Table 5: Operation irregularities of the twine binder unit
Trouble Cause Cure Reference