Vicon RV 4116, Operation And Maintenance Manual

Page: 191 / 192

4
83-011-0.
fm
ID
M
English
- 25 -
▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬ Electronic control system
E12 Bale density too high
The bale pressure is higher than
the maximum allowed value.
Decrease the forward speed.
The bale density potentiometers
are not regulated properly.
Contact the Technical
Assistance Centre that is
authorised by the manufacturer
E14
Electric power of "twine/net
insertion arm motor" too low Supply voltage too weak (lower
than 9 V)
Turn off the equipment
Check the correct operation of
the battery and the electric
wiring integrity
E15
Power voltage "PWR OUT" too
low Supply voltage too weak (lower
than 9 V)
Contact the Technical
Assistance Centre that is
authorised by the manufacturer
E16 Power voltage "5V OUT" too low
Supply voltage too weak (lower
than 4,5 V)
Contact the Technical
Assistance Centre that is
authorised by the manufacturer
E17
Overheating or overload of
electronic card
The temperature of the
electronic card is higher than
70°C
Cool down electronic card
If the problem persists, refer to
the assistance centre authorised
by the manufacturer.
E18 Reset of the default values
The default values of the system
have been reset.
Contact the Technical
Assistance Centre that is
authorised by the manufacturer
Table 1: Operation failures
n° Alarm description Cause Cure